Derek92994's 700 Ser II White Oak conversion

[derek92994]

Measure R85, one lead on each side..

R85 is 20.5 ohms

 

[laatsch55]

Should be 20,000 ohms...

 

[derek92994]

Should be 20,000 ohms...

20.5 Ohms on the 200k Ohms range of multimeter

 

[derek92994]

Hey Lee I need to rest, fatigue is killing me today, really difficult to stay awake.

 

[laatsch55]

Me too Darc, I need to get to bed myself...

 

[derek92994]

R85, 20.5 (200k ohm scale on multimeter)

 

[laatsch55]

So, do you think that is 20.5K ohms?

 

[derek92994]

So, do you think that is 20.5K ohms?

If I put it on the lower scale/range on dmm, then it says out of range, 200k scale/range is needed to get the 20.5 value. If I put the dmm on the 2M range I get 0.020

 

[derek92994]

 

[laatsch55]

On the diode test of Q2, what does 1 represent on your meter?

 

[laatsch55]

View attachment 47967 View attachment 47968

Is it out of range on the 20K range?

 

[derek92994]

 

[derek92994]

Yes its out of range on the 20k range

 

[derek92994]

 

[derek92994]

On the diode test of Q2, what does 1 represent on your meter?

Q1 is the one giving strange results, Q2 seems ok (around 600 value you mentioned if I remember correctly)

 

[laatsch55]

Q2 is a PNP . So as you are looking at it , black on the right pin red on middle then far left.

 

[derek92994]

 

[derek92994]

 

[Gepetto]

If I put it on the lower scale/range on dmm, then it says out of range, 200k scale/range is needed to get the 20.5 value. If I put the dmm on the 2M range I get 0.020

It is a 20.5K ohm resistor so your meter is reading accurately.

 

[derek92994]

Q2 Results Up Here ^^