Derek92994's 700 Ser II White Oak conversion

Gepetto

Administrator
Staff member
Joined
May 15, 2011
Messages
13,915
Location
Sterling, MA
Tagline
Old 'Arn Enthusiast
It would be better if you used VR1 and VR2 rather than left and right so we can be sure we are tying it to the schematic.

I am suspecting VR1 to have the bogus voltages but that needs to be confirmed by Darcy
 

derek92994

Veteran and General Yakker
Joined
May 1, 2013
Messages
7,226
Location
Australia
Tagline
Those who enter the man cave will get WOPLed
It would be better if you used VR1 and VR2 rather than left and right so we can be sure we are tying it to the schematic.

I am suspecting VR1 to have the bogus voltages but that needs to be confirmed by Darcy
VR1:
C pin: 20.2 (the relays engaged for 2 power ups just now, previously this voltage was 7.6)
C pin 2nd test: relays did not engage, you get 7.6 volts when this happens, meters peg 30 seconds after power down then go down slowly
A pin: 0v
R pin: 2.5v

VR2:
C pin: 0v
A pin: -20.5
R pin: -17.9
 

derek92994

Veteran and General Yakker
Joined
May 1, 2013
Messages
7,226
Location
Australia
Tagline
Those who enter the man cave will get WOPLed
Also caps discharge themselves quite fast, down to 1 or 2 volts within 30-60 seconds when the relays do not engage.
 
Top