Derek92994's 700 Ser II White Oak conversion

It would be better if you used VR1 and VR2 rather than left and right so we can be sure we are tying it to the schematic.

I am suspecting VR1 to have the bogus voltages but that needs to be confirmed by Darcy
 
Gepetto said:
It would be better if you used VR1 and VR2 rather than left and right so we can be sure we are tying it to the schematic.

I am suspecting VR1 to have the bogus voltages but that needs to be confirmed by Darcy
Click to expand...

VR1:
C pin: 20.2 (the relays engaged for 2 power ups just now, previously this voltage was 7.6)
C pin 2nd test: relays did not engage, you get 7.6 volts when this happens, meters peg 30 seconds after power down then go down slowly
A pin: 0v
R pin: 2.5v

VR2:
C pin: 0v
A pin: -20.5
R pin: -17.9
 
Also caps discharge themselves quite fast, down to 1 or 2 volts within 30-60 seconds when the relays do not engage.
 
Maybe the fans picked up a small particle of metal and threw it inside the amp?
 
1230pm, 36 Degrees Celcius, looks like we may be in for a storm this afternoon.
 
I'm good on mini-grabbers Darc, Pomona's....pretty good stuff too...
 
You must log in or register to reply here.
Back
Top