New build for shop system

[laatsch55]

A 2019?? How did it lose power?
Somebody sleepin?

 

[AngrySailor]

A 2019?? How did it lose power?
Somebody sleepin?

Probably computer issue. When the computer has a brain fart things go bad. These use common rail electronic controlled injection and computer controlled exhaust valve timing. There is no mechanical camshaft, everything is is actuated by servo oil pressureand solenoids/volumetric control units and sheiit.

 

[bill7621]

Well, somebody won't be getting an "attaboy".

 

[laatsch55]

Yeah, no shit. Having to offload your cargo shoots that loads profit in the ass...

 

[AngrySailor]

Yeah, no shit. Having to offload your cargo shoots that loads profit in the ass...

They’re gonna off load it to another ship or barges, not dump it in the lake, but yeah, they’re not making shekels...

 

[orange]

Probably computer issue. When the computer has a brain fart things go bad. These use common rail electronic controlled injection and computer controlled exhaust valve timing. There is no mechanical camshaft, everything is is actuated by servo oil pressureand solenoids/volumetric control units and sheiit.

Marvin the Paranoid Android would have complained but done better.

 

[AngrySailor]

Marvin the Paranoid Android would have complained but done better.

The best way to fuck up a nice running Diesel engine is to let a computer anywhere near it

 

[orange]

Ah, but Marvin's eternal groaning is worth hearing.

 

[orange]

PS I KNOW, GM WAS EXCELLENT AT THIS TASK.

 

[roccus]

Brought the CD player in. Needed a pillow under it to prevent skipping. RIP clock... fell off the wall. Serious results and it’s only a stock PL400...

LOL the clock, same here shelves, walls everything!!!!

 

[J!m]

Interior wreckorator...

 

[AngrySailor]

Back at the shop cabs. Made up a template for the screw holes, speaker holes and ports so everything will be the same and easy as pie. Just used the scrap wood thatcobered the lift of MDF. Screwed the face board and the centres down to the sacrificial table to hold everything in place. Worked out real easy. Going to get a speaker just to check for then carry on with the other three faces.

 

[AngrySailor]

One box glued except for the face and braces. There’s going to be two 6” round ports, about 9” long which should tune them to 26hz resonance. I’ll wait till I pick up the port material tomorrow to make sure the size is right when I cut the holes.

 

[laatsch55]

Lots of progress there Andrew..

 

[laatsch55]

Is that you peeking over the box ?

 

[AngrySailor]

Is that you peeking over the box ?

No, that’s Trever, who generously let me make a mess in his shop. Darcy is the midget and can’t even see over the box. These will come together quick now. More time to hang them and set things in place than actual fabrication

 

[laatsch55]

I'd be the opposite..

 

[orange]

I just realized...that box is the size of my dumpster.

Holy Cow!

 

[AngrySailor]

Used some scraps for a jug to cut the port holes. Seems to be going ok. All the face boards should be done soon.

 

[AngrySailor]

Face boards done. 9” is the magic number for the ports. I cut two at 11” will assemble all the cabinets to the point of the face boards, then temporarily screw one face board on and install the speakers, run a frequency sweep to check resonance then cut the ports as required. The other three cabinets will be ported the same.