700B blew one Right channel 5A supply fuse

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,987
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
Drilled holes or built a fixture?....CARVER!!!! What did the factory use for a fixture??? I know you're out there!!....
 

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,987
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
Did you drill holes in the board for the wires ir did you build a fixture ro help you with sildering?? The other was to flush Bob out when he's lurking...
 

62vauxhall

Veteran and General Yakker
Joined
May 14, 2014
Messages
2,324
Location
Southwest Kootenays BC
Tagline
No such things as bad days, just bad moments
Did you drill holes in the board for the wires ir did you build a fixture ro help you with sildering?? The other was to flush Bob out when he's lurking...
Fixture? As in what am I doing to hold the board in place while soldering?

A plastic container to rest the board on and an alligator clip to hold the wire in place.

IMG_2094.jpg IMG_2095.jpg
 

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,987
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
Hole #7, was orange, goes to the collector bus bar left channel positive drive....just above where the fused B+ plus wire is soldered in at...
 
Top