Russ' 700B Wopl

Wiring the backplanes tonight. Had a pretty slack day. Kicked y crews out by 7, did paperwork till 10, then went to the eye doctor for three hours. Came home , took a nap, now back at it.
 

Attachments

  • 20150918_190128.jpg
    20150918_190128.jpg
    96.9 KB · Views: 47
Done wiring the backplanes ....
 

Attachments

  • 20150919_000409.jpg
    20150919_000409.jpg
    102.2 KB · Views: 50
Got some time today....time to strip..this one gets a new chassis..
 

Attachments

  • 20151025_120409.jpg
    20151025_120409.jpg
    98.2 KB · Views: 49
Some extensive work was done on this. New emitter resistors...chassis,reinforcement...
 

Attachments

  • 20151025_173759.jpg
    20151025_173759.jpg
    97.3 KB · Views: 49
  • 20151025_173749.jpg
    20151025_173749.jpg
    86.7 KB · Views: 45
Transformer separated from chassis...
 

Attachments

  • 20151025_182923.jpg
    20151025_182923.jpg
    97 KB · Views: 52
Not really Glen. Some very good work was done to it. It looks like all of it was preventative in nature. A lot of new wire, very well done. Somebody knew what they were doing.
 
Not really Glen. Some very good work was done to it. It looks like all of it was preventative in nature. A lot of new wire, very well done. Somebody knew what they were doing.
The chassis repair is first class I would guess it may have been dropped. The wiring looks good enough to reuse but if you are going to do it then then dot right!! "Lee's way"
 
I'll leave the #14, but change out the rest. The #14 is very nice wire...
 
There is actually #14 for rails and speaks....
I used the following my build

power from caps to fuse and ground wires to DCP #12
output from back plates to DCP #14
feed from fuse block to back plate #16
ground wires#16 and #12
120volt wiring #14
back plate to control board #20
DCP and meter power supply and volume control wires areshielded #20

Lee the #12 is a bit heavy and hard to work with but does look good
the power plug is rated at 15 amp and I have some 10' #14 ac cords from EBay
 
I've run some of Navo's #12 from the BR to the caps, it does take some finneglin to get it in there...
 
I've run some of Navo's #12 from the BR to the caps, it does take some finneglin to get it in there...

Yes sir Navo's got good wire stuff and interesting avatar's
I did the #12 as well. Is a good thing the holes are big enough. The next one I do I will drill some holes above the ones that it comes with for the DCP power connection
 
Brand new fuse holders...
 

Attachments

  • 20160123_225039.jpg
    20160123_225039.jpg
    85.3 KB · Views: 51
IEC plug. Joe did a heck of a job fitting that in thete.....
 

Attachments

  • 20160123_225538.jpg
    20160123_225538.jpg
    75.6 KB · Views: 48
New binding posts....
 

Attachments

  • 20160123_230516.jpg
    20160123_230516.jpg
    81.9 KB · Views: 40
Back
Top