Jason's Phase Linear P3600

[NavLinear]

And the LED had to be siliconed back in. Nav needs ro send some of those LED holders he makes..

I may have a couple of them laying around. If I do I'll include them in the Cabbage Case.

 

[Skynyrd77]

I may have a couple of them laying around. If I do I'll include them in the Cabbage Case.

I need a cabbage case here for this 700 that needs to head to lee!! Is that a empty lee??

 

[laatsch55]

No, that one's full of SAE 2400. When Ron gets the audition 700 he can send it your way.

 

[Skynyrd77]

No, that one's full of SAE 2400. When Ron gets the audition 700 he can send it your way.

Ok cool thanks lee! If I start moving to fast for ya on shit just tell me to chill lmao. I get excited

 

[laatsch55]

There's 2 amps ahead of ya..

 

[laatsch55]

I'll try to see if I can get that month down to a week..

 

[Skynyrd77]

There's 2 amps ahead of ya..

Ok I will sit patiently and wait my turn!!

 

[laatsch55]

That's way better than the alternative-------doing it yourself..........

 

[Skynyrd77]

That's way better than the alternative-------doing it yourself..........

Lmfao!! Very true

 

[laatsch55]

Found your hum. Bad wiring harness pins coming off the power supply board. Broken solder joints.

 

[laatsch55]

Here we go..

 

[laatsch55]

Joe, the PL 4000 isn't the only PL pre-amp that can give you a 48KHZ wall to wall square wave....

 

[laatsch55]

Well, 53khz actually....

 

[Gepetto]

Well, 53khz actually....

Due to some flakey connection inside the preamp Lee???

That was the PL4000 symptom.

 

[Skynyrd77]

Is all this chatter good or bad??

 

[Northwinds]

Looks great Lee!!!

 

[NavLinear]

Is all this chatter good or bad??

The total harmonic distortion and noise graph looks good Jase. Up to about 50 kHz it's around 0.04% or maybe a bit higher and moves up a bit to something near or above 0.1% - pretty damn good. It's hard to make out the graduations on the small display but Lee can print out the discrete data points.

 

[laatsch55]

Yes Joe, Now I'm chasing a bad channel..as in not there..

 

[laatsch55]

I've got the bypass caps accross pins 1,5 instead of 4, 8. For the first problem...

 

[Skynyrd77]

Went from easy to hard eh!!!