Derek92994's 700 Ser II White Oak conversion

No....ccheck em all except input from RCA jacks and the last 3 on the left side of each connector block....those are ground and plus and minus.....well fuck, check those too..
 
Driver input voltages
Left
1L 0.1mv
2L 0
3L 105.5v
4L -1.5mv
5L 0
Pnpl -0.9v
6L 0.4mv
7L 105v
8L 2.2mv
9L 0.9v
10L 0.3
11L 105v
12L -105v

Right
1R 0.1v
2R 0
3R -105v
4R -0.7mv
5R 0
Pnpr -0.8v
6R 1.2mv
7R 104.7v
8R 3.1mv
9R 0.9v
10R 0.3v
11R 105v
12R -105v

time for a cig
 
Remember when I couldnt solder too well, heres a pic of it, could this be causing problems?
21C9D2D3-54D6-42D3-9922-EEB0D0DD983D.jpeg
 
I don't think so Darc... besides the pop were you hearing any increased hum?
 
laatsch55 said:
I don't think so Darc... besides the pop were you hearing any increased hum?
Click to expand...
No hum, it just randomly pops. About 2 weeks after first output replacement, then 2 days after 2nd output replacement.
 
Do you remember if the bad outputs were in the same position in the column?
 
There has been no issues running the spare amp, I also run it off the PL pre but i need to run an earth wire between the 2.
 
Have you just run the amp with no pre connected for a long period of time to see if anything repeats?
 
You must log in or register to reply here.
Back
Top