- Joined
- Oct 15, 2014
- Messages
- 3,419
- Tagline
- ---not quite right
Hey guys, Sorry it’s not Phase Lineral related but I have a question regarding these amps. I have two powering my low frequency cabinets, both are operating bridged @ 4 ohm for 3200w each. Sound is ok, but channel 2’s clip light comes on both amplifiers seemingly before max output? I have momentarily driven them hard enough that channel 2’s clip light is solid then channel 1’s Clip light will light. Channel 2’s gains are down, both amps fed signal to channel 1 from my active crossover. Only channel 1’s signal light is lit as would seem normal. (Actually channel 2’s occasionally light real dim) This seems wrong but I can’t find any information. Any ideas?
Attachments
-
1.4 MB Views: 6