Przem's Phase Linear 700 Series II White Oak Conversion

Amp done, power cord done...
 

Attachments

  • SAM_0743.jpg
    SAM_0743.jpg
    89.1 KB · Views: 39
  • SAM_0742.jpg
    SAM_0742.jpg
    85.8 KB · Views: 45
  • SAM_0741.jpg
    SAM_0741.jpg
    86.6 KB · Views: 47
  • SAM_0740.jpg
    SAM_0740.jpg
    84.7 KB · Views: 38
Looking good Lee! As always a great job.

That sure looks like a FreeWave RF modem in the first photo. Do you use them in the field to transmit electronic health functions? If you have a slow data rate those things are awesome.
 
Yep, that's a Feewave radio. They come in our pumpoff controllers but we don't use them...
 
laatsch55 said:
Hardwire to the drive or starter panel....
Click to expand...

Ok. We use them to bi-directionally transmit sensor data from one platform to another or from a platform to a ground station - or visa-versa.

It sounds like the RF modem (radio) in your case was intended to transmit data over a short distance but since hardwiring was an option due to the close proximity of the interface circuits that would be the preferred option. Less shit to go wrong.
 
We are using a radio to control a pump accross a distance of 3/8 mile. It's a converted security system RF. The freewave would be better I suppose but have no experience with em. Have quite a few laying around....
 
laatsch55 said:
We are using a radio to control a pump accross a distance of 3/8 mile. It's a converted security system RF. The freewave would be better I suppose but have no experience with em. Have quite a few laying around....
Click to expand...

We sometimes bump up the output wattage from the approximately one watt output to five watts using an external amplifier and can get 30 to 50 mile coverage with low gain antennas on both ends. Of course one end if not both are in the air so we have line of sight. The FreeWave modems are quite capable and can be programmed using software you already have.
 
Can they communicate directly with a PLC like the Allen Bradley 1760 Pico?
 
laatsch55 said:
Can they communicate directly with a PLC like the Allen Bradley 1760 Pico?
Click to expand...

Not directly. Normally one would have a RF modem at each end and translate and/or format the transmitted / received data as necessary.
 
I just need a go/no go signal. Most of our remote requirements are to turn something off when something else fucks up like pumps or pumping units. High tank kills, high pressure kills...
 
laatsch55 said:
I just need a go/no go signal. Most of our remote requirements are to turn something off when something else fucks up like pumps or pumping units. High tank kills, high pressure kills...
Click to expand...

Is a wireless system desired?

One thought is this data could be linked to a cell tower and wake someone up when things go tits up in addition to controlling the system it is monitoring.
 
I'd never get any sleep. And yes wireless would be way cool in a couple places we have. Save burying a lot of commo wire..
 
laatsch55 said:
I'd never get any sleep. And yes wireless would be way cool in a couple places we have. Save burying a lot of commo wire..
Click to expand...

Just send the data to Timdalf. :happy3:

The FreeWave modems require a serial data input. If the rig sensors data are not serialized then a translator would be required. On the other end the modem output is serial so another conversion may be required to translate this to Allen Bradley speak.
 
You must log in or register to reply here.
Back
Top