Glen's 700 series II build

[laatsch55]

Yours matches my sample Lee. Glen not sure what version you have.

Maybe Don can shed some light on it...

 

[grapplesaw]

Here is what I have. Lee Can you please send photo of other side

updated photo

 

[Gepetto]

View attachment 19713 a


Here is what I have. Lee Can you please send photo of other side

You have a RevA, Lee and I have RevB samples.

 

[grapplesaw]

You have a RevA, Lee and I have RevB samples.

Just saw that as you posted Joe

 

[grapplesaw]

Maybe Don can shed some light on it...

Lee I am going to email Don and clear this up
thanks everyone

 

[grapplesaw]

My blanks don't have any D4's either, just 1 thru 3....

Lee Can you post a photo of the other side as well

 

[laatsch55]

Yep, know exactly why you ask...here ya go....

 

[gadget73]

What is D4 wired across? If it sits across the relay coil, then you probably want it there. It would be used as a flyback diode in that spot to keep it from smoking the driver transistor. If not that, the guy that made it probably knows

 

[grapplesaw]

Yep, know exactly why you ask...here ya go....

These boards are realy different
I have emailed Don to find out what is up
thank again for photos

 

[laatsch55]

You're very welcome Glen...

 

[grapplesaw]

The problem today is its like 80* out today
got to do yard work

 

[grapplesaw]

I heard back from Don today
these boards are NFG. I will have to strip this one down and wait for replacements

 

[Lastplace]

How did they get the water to stay in the pool?

 

[NavLinear]

How did they get the water to stay in the pool?

You confused me for a minute but that doesn't take much - still cracking up!

 

[P.L.F.]

You confused me for a minute but that doesn't take much - still cracking up!

But that's not the answer ....

 

[grapplesaw]

Back at the project again
got new DCP boards from Don, thanks again for your great service, and have finished all the wiring.

I am looking for the thread which I read with all the steps to bring this puppy to life, so if anyone can help me please to find it I would be thankful. Want to put some juice to it before putting in the power transistors

 

[laatsch55]

Looking good Glen!!!!!

 

[Gepetto]

Back at the project again
got new DCP boards from Don, thanks again for your great service, and have finished all the wiring.

I am looking for the thread which I read with all the steps to bring this puppy to life, so if anyone can help me please to find it I would be thankful. Want to put some juice to it before putting in the power transistors

View attachment 20026 View attachment 20027 View attachment 20028 View attachment 20029 View attachment 20030

Glen
Don't throw power to anything with those long screws installed that I see jutting through the standoffs in your picture unless they are insulated with a nylon washer from the heat sink side.

You will not like the results.

 

[Gepetto]

Glen
Don't throw power to anything with those long screws installed that I see jutting through the standoffs in your picture unless they are insulated with a nylon washer from the heat sink side.

You will not like the results.

The last picture Glen.

 

[grapplesaw]

The last picture Glen.

Thanks Joe
I will check for ground fault first
Yes they are going through rubber hose to avoid any grounding
have a look at this photo and tell me if ok