Derek92994's 700 Ser II White Oak conversion

[derek92994]

Tests ok!

 

[laatsch55]

Not bad for being run hard for 10 years
1st gen backplanes with soldered outputs ...
Good job Darc!!

 

[derek92994]

Not bad for being run hard for 10 years
1st gen backplanes with soldered outputs ...
Good job Darc!!

thanks Lee. Waking up to some Led Zeppelin, breakfast at 315pm then some counselling at 4pm

 

[derek92994]

Gave her a drive as hard as I could until mids cracked then backed her off a bit.
Crystal Method - Cherry twist then Vapour Trails
Shpongle - DMT
My ears are ringing, fck that was good!
Need 15’s but gonna have to wait.

 

[laatsch55]

Need a set of k's bud.

 

[Fishoz]

Surprised you still have ears Lee…

 

[laatsch55]

Aw shit Fish, they're in good shape!!!

 

[derek92994]

TURN IT UP!

 

[Fishoz]

You’re still a puppy d2…it does take its toll. But….I do agree ya gots to crank it sometime…!

 

[derek92994]

This house wont support K’s, D9’s might work.

 

[derek92994]

I just noticed there are bias test points on the backplanes. Could someone please explain the difference between bias test points on control board vs the backplanes?

 

[Gepetto]

I just noticed there are bias test points on the backplanes. Could someone please explain the difference between bias test points on control board vs the backplanes?

The backplanes have top half and bottom half test points which should show nearly equal but opposite polarity bias readings. The control board only has a test point for the positive top half which is the same as the backplane top half