Derek92994's 700 Ser II White Oak conversion

About 10 minutes for upload. I powered it down after 30 seconds.
 
To catch folks up, we had a fuse holder problem. Powered up fine with rail fuses out. +108DC, and - 108DC for the rails.....This ones gonna be a hottie....Rail fuses are now bck in and with the next power up we are prayin for DC relay clicks




OK D2 hit it!!

I was wondering what happened. Too cool - this has been fun to watch.
 
Amen, just one more thging before you power down and button it up. We are going to check DC offset. Positive test lead to positive speaker post in 200OHM setting. DC offset should read -9 to -17 millivolts. Check both channels and post results.
 
Gives me time to grab another cold one. Have your latest tape playing, Derek - the pre-recorded mix on the TDK AD100. Nice job! Side 2 song 1 is Angel City, right.

Nando.
 
Amen, just one more thging before you power down and button it up. We are going to check DC offset. Positive test lead to positive speaker post in 200OHM setting. DC offset should read -9 to -17 millivolts. Check both channels and post results.

-15 to -16 on one channel

-17 to -18 on the other
 
Gives me time to grab another cold one. Have your latest tape playing, Derek - the pre-recorded mix on the TDK AD100. Nice job! Side 2 song 1 is Angel City, right.

Nando.

Its the Angels.
 
DUDE!!!! YOU DID IT!!!

Power down, check cap voltages, button er back up.....what happens now is pure sonic bliss bud....let us know what ya think....
 
DUDE!!!! YOU DID IT!!!

Power down, check cap voltages, button er back up.....what happens now is pure sonic bliss bud....let us know what ya think....

Wait until caps get down to how many volts before buttoning up?
 
The caps bleed down quick, already down to 1 volt. Buttoning up now
 
Whatever you, yourself can stand.....anythiung less than 10 is fine..
 
You'd think drummergrl might be interested in this thread?

Nando.
 
Back
Top