Russ' 700B Wopl

[grapplesaw]

Glen, with the new chassis we can standoff at least another 3/4"...

All over but the testing and shakedown....

Great. I got mine at 1-5/8 high, so probable leave the ones I did alone. I was doing it just to allow extra air between the board and backplane.

 

[grapplesaw]

Glen, with the new chassis we can standoff at least another 3/4"...

All over but the testing and shakedown....

Here is a 400 with 1-5/8 high. A squeaker for sure.

 

[laatsch55]

I heard ya bought another D-500.....

 

[laatsch55]

Much better, not GREAT, but less than half of what I started with.....

 

[grapplesaw]

I heard ya bought another D-500.....

Yes
I not sure of what I got myself into this time. I am sure it can be sorted out. Thanks Ed

 

[grapplesaw]

Much better, not GREAT, but less than half of what I started with.....

Mr. Scott more power to the shields.

 

[Gepetto]

Much better, not GREAT, but less than half of what I started with.....

Do you have the 30 or 80KHz filter on Lee?

 

[laatsch55]

80 Joe....

 

[orange]

Mr. Scott more power to the shields.

I HAVE FULL POWER CAPTAIN BUT I CANNAE SAY HOW LONG SHE'LL HOLD!

 

[laatsch55]

Actually it's on the K-Horn filters right now....

 

[laatsch55]

Joe , that was in "Level" mode, there are no filter options in "Level" mode. However, in Amplitude/Noise mode i can switch in Band Pass filters, Bandwidth Limiting Filters and Weighting Filters......I did not do that.........yet.....

 

[Gepetto]

Joe , that was in "Level" mode, there are no filter options in "Level" mode. However, in Amplitude/Noise mode i can switch in Band Pass filters, Bandwidth Limiting Filters and Weighting Filters......I did not do that.........yet.....

You usually kick in the 30KHz filter. Noise in the 30-80KHz spectrum is interesting but not very relevant.

 

[laatsch55]

To be consistent between us, is that the filter you use for checking residuals??

 

[Gepetto]

To be consistent between us, is that the filter you use for checking residuals??

I check with 30KHz on Lee but also look with the 80KHz filter as information only. I also measure with the HP3478A which has a 100KHz bandwidth for correlation. At these low levels, cables, shielding and proximity are contributors.

 

[laatsch55]

The AP will let you go out to 300khz .....

 

[laatsch55]

Russ is gonna be tickled with this one. Been hammering on it for a good 20 hours.....left it on all night, starting to sound really good.

 

[fitz43]

Russ is gonna be tickled with this one. Been hammering on it for a good 20 hours.....left it on all night, starting to sound really good.

How did you sleep?

 

[laatsch55]

I wasn't playing music while asleep Doug, 28 hours on, 20hours play time....

 

[laatsch55]

While Justin Case's 400 is getting shook down we'll take the final measurements on Russ' 700 and get it gone Monday....

 

[laatsch55]

Residual noise, right channel, 10hz to 31,500hz IEC A-WTG