Phase Linear 4000 Series two.
- Thread starter VSAT88
- Start date
- Joined
- Jan 14, 2011
- Messages
- 74,874
- Location
- Gillette, Wyo.
- Tagline
- Halfbiass...Electron Herder and Backass Woof
Went searching thru all my old junk to see if I had any OPT I could pop in and guess what. In the past I had been sorting the old OPT by the date code and calling them 'matched" because I knew they all came out of the same unit, they all had the same designation/type (IE 15025,15024,) number and by the date code even though I did not know it was a date code.
Got all the outputs in and a new .33 emitter resistor. Got a few resistors to replace on the board. May do all of them. I saw this kit "https://www.ebay.com/itm/372640636069?chn=ps&mkevt=1&mkcid=28" over on the Bay. Think I may get it and sling it in with the new caps for the PL36.
Its actually kinda rough in person. I mean not terrible but not an amp I would go all WOPL over 
View attachment 66978
View attachment 66979
View attachment 66978
View attachment 66979
Oh OK , I see that you took the 7.5K Resistors out? bottom pic and I see a blob of solder by the Cap (Top Right ) I can look later at my working board , but its full comp. the Zennor diode has been replaced & I would add sockets for the op-amp , I had a lot of problems w the Pots so I would clean them, and ohm them out.
Oh I just bought some silicone wire Wow its very Flexible I used the 20AWG but the next one is going to be 22awg https://www.amazon.com/dp/B0881HCN37?psc=1&ref=ppx_yo2ov_dt_b_product_details
Oh I just bought some silicone wire Wow its very Flexible I used the 20AWG but the next one is going to be 22awg https://www.amazon.com/dp/B0881HCN37?psc=1&ref=ppx_yo2ov_dt_b_product_details
Just de soldered on side of those two resistors to do a firm check on them. They will both be replaced. Lots of heat on those two. I already have the sockets for the op amps, just trying to decide what ones to use. I do not understand why only one op amp has a socket on this board?? I will replace all of the diodes on the board, transistors and resistors. I think I have two bias pots, brand new ones not 100% though. Gotta look. Did you use the .22awg on a PL amp ?
Last edited:
Here the pic of the Connecters I added and is wired w 20awg but it tight (not a lot of room behind the board. I will make the Bias wires longer from the board so they can move around the board, I'm using 4-connecters all wired from the backplane and power and all are wired for the PL14_20G1 . I converted it to Full comp so the board has been modified. PL had a lot of design work and thinking about how to do it and this is REV 1 Yellow tape is holding the connectors for the PL.
Attachments
The Goal is to have a test fixture since I'm doing a bunch of them, I have a lot of parts so I'm going to update all the old PL boards w news parts and Resistors and them I can swap out them w the new PL14_20G1
This PL 400II has already had 2-PL14_20G1 boards in it and the Original modify PL one.
This PL 400II has already had 2-PL14_20G1 boards in it and the Original modify PL one.
