Inverted back plates build

I like the harness clips to hang off the wiring,,,,,good idea....
 
So what has changed
my HDR photos look very bad when posted
is there a change to the image size in the forum?
 
laatsch55 said:
I like the harness clips to hang off the wiring,,,,,good idea....
Click to expand...
I was doing something different with this build so I try several new ideas. I spaced the control board about 1/2" higher to give more room and cooling area
The clips made it easy to hold the wiring about half way between the back plate and control board
 
Glen, on some early builds of mine I actually relocated the AC mains in and fuse to the left side between the big caps. That was actually a pretty clean installation...
 
laatsch55 said:
Glen, on some early builds of mine I actually relocated the AC mains in and fuse to the left side between the big caps. That was actually a pretty clean installation...
Click to expand...
Ok here's the whole story. I saw your posts some years ago about doing just that. I believe the cord came out the side by the transformer. I did not want to have the power cord showing like that so never wanted to try it. After looking and thinking about it I drew up a wider chassis and discussed the potential to build it at Joe's fabricator. Joe said it would be way to expensive so I ditched the idea. Having purchased a chassis from Joe I was eyeing at the left over and thus we have this build. Go or bad it was just fun to do.
 
I agree Glen , I think yours is a good build. It's good to see different ways to do things...
 
laatsch55 said:
I agree Glen , I think yours is a good build. It's good to see different ways to do things...
Click to expand...

Well you have few in your box of tricks. But thanks

So I have tried different editor setting to see if photos are better
See what you think

I think it about the same

image.jpg
 
It is Alive

The hardest part was putting in the drivers. I remembered something about magnets so I got out my little pocket magnet pencil It made things much easier but still was a fight
I found that checking the leg alinement in an old base helped a lot
I must have stewed up something with the little inserts as they stuck up from the board. Did I put them in from the wrong side?

image.jpg
 
Last edited:
Here is the DC offset at outputs 3mv and .8 mv

Any fine tuning this ??

I will have to redo this one
I just noticed it was set on Ac volts

Well you got me after all Lee!!!

image.jpg
 
Last edited:
I hope the rails are DC.....seriously Glen, good to see it finished....how does it sound??
 
You must log in or register to reply here.
Back
Top