Ok, here they are. Two things, when you get them you will see the P-strap will not contact the chassis when bolted so you will have to sand the bottom of the bracket to get the P-strap to contact the chassis. It has to contact the chassis in order to do it's bias thang as the chassis heats up. I am sending 2 extra P-Straps and 4 2N5088's. You will have to spread the P-Strap and punch out the old 2N3403, then clean out the old epoxy with a small file and the install the 2N5088, squeeze it together with a 4-40 screw and nut , then mix up some 5 min epoxy and put a dab inside the P-Strap opposite the lead side. The 2N5088 has a different pin out than the 2N3403 so download the data sheet. When you add wire to the leads to make it long enough top get to the back of the board, use #24 wire. use really small heat shrink or the bundle won't fit through the "tunnel" in the bracket. At the small end of the bracket, it is indented to accept a small cable tie. That will keep the strain off the leads, and prevent breakage....