The Phase Linear 400 Guinea Pig

AHA!! No bias voltage...what resistor was that Joe....R75?
 
R35 replaced witha 1 ohm 1/4 warr MO. Left channel R35 also out of spec, it was reading 10.5 ohms. Bias now holding 385mv. Back on the AP....
 
R35 replaced witha 1 ohm 1/4 warr MO. Left channel R35 also out of spec, it was reading 10.5 ohms. Bias now holding 385mv. Back on the AP....

Looks like those 1 ohm fuses did their job. Now that you have the wire relocated from the backplane, that should not occur again.
 
Yep, clian and green on the scope too.. back on the K's while Timdalf's gets a new lightboard...
 
THE PIG LIVES-AGAIN!!
 

Attachments

  • SAM_0109.jpg
    SAM_0109.jpg
    92.1 KB · Views: 50
  • SAM_0108.jpg
    SAM_0108.jpg
    90.9 KB · Views: 62
Thanks Joe, this is still one BAD ASS little 400...DAYAM!!
 
Back
Top