Quick Check of Control Board Function - Pictures of test set up

Sunnbobb

Sunnbobb

Journeyman
#1
Joined
May 25, 2023
Messages
205
Location
Mount Vernon, WA
Tagline
Bikes, baseball and big amps.
#1
I've set up PL400 #6 to run the above test from the WOPL docs. Before I put the juice to it, I wanted to make sure it is set up the way suggested in the docs. Joe, If you have a minute, could you confirm this is set up right? Thanks! Richard


20240603_193522[1].jpg 20240603_193412[1].jpg
 
Gepetto

Gepetto

Administrator
Staff member
#2
Joined
May 15, 2011
Messages
13,927
Location
Sterling, MA
Tagline
Old 'Arn Enthusiast
#2
Sunnbobb said:
I've set up PL400 #6 to run the above test from the WOPL docs. Before I put the juice to it, I wanted to make sure it is set up the way suggested in the docs. Joe, If you have a minute, could you confirm this is set up right? Thanks! Richard


View attachment 81727 View attachment 81728
Click to expand...
Richard, It appears that your board is built as full comp by the picture with the exception that you are missing the 1 ohm resistors in the R38R slot (and possibly the R38L slot as well). The debug instructions you appear to be following are for a quasi comp test, not full comp (I am drawing from memory and will have to check that). You are definitely missing a resistor in the R38R slot however.
 
Sunnbobb

Sunnbobb

Journeyman
#3
Joined
May 25, 2023
Messages
205
Location
Mount Vernon, WA
Tagline
Bikes, baseball and big amps.
#3
Yup, full comp. And here is a screenshot of the test set up I am following. Sorry, I should have posted it so you didn't need to go digging. test.jpg I'm just trying to out do Gene on leaving R38 out. lol
 
Last edited:
Gepetto

Gepetto

Administrator
Staff member
#4
Joined
May 15, 2011
Messages
13,927
Location
Sterling, MA
Tagline
Old 'Arn Enthusiast
#4
Sunnbobb said:
Yup, full comp. And here is a screenshot of the test set up I am following. Sorry, I should have posted it so you didn't need to go digging. View attachment 81730 I'm just trying to out do Gene on leaving R38 out. lol
Click to expand...
What are you trying to debug? What is the problem you are chasing? If you are chasing a problem, the lack of R38 could be instrumental.
 
You must log in or register to reply here.
Top