Phase Linear 400 Amplifier Upgrade to WOPL

laatsch55 said:
His last post-----

can find transmitters and receivers all day, but no transceivers (don't need duplex, neither!).

We tow aircraft across the field from our ramp to the terminal, and our brake rider communicates directly with the tower, but also confirms with the tug operator, who in turn communicates back to the brake rider. I guess two transmitters and receivers could be purchased which could then be wired into one box, one jack...

I was only singling out avionics guys as they might have something in mind even a dumb airframes guy could concoct. __________________
Dual 1019/Grado F1+, Sony PS1, Knight KN-775, Advent Legacy
Click to expand...

One question is WHY?
 
Whatever happened to this project???????????????????????????????
 
It's on hold as I had to clear my area for several hurry-hurry-rush-rush projects. I'm doing my hands on stuff for this at my work space in my spare time - the spare time hasn't existed for a while and now my space has been cleared of my fun stuff and now I have other junk on it! One would think with sequestration a possibility that test and evaluation would suffer but we're busier than hell now.

I did use the HP 8903A to test some instrumentation channels for the 3dB roll off points for the frequency response of a few of our instrumentation telemetry signal conditioner circuits. I compared these numbers with our measurements using a spectrum analyizer and they tracked well. Just wanted to get more familiar with this test insturment.

One of our requirements is to measure the environmental flight conditions of a new drone that the navy will be using in the future. This data will be used to define the flight envelope and also for future payload electronics. We installed multiple accelerometers and other sensors to help define the this environment. Our first flight is not too far off - or so I'm told!! Too much fun.
 
NavLinear said:
It's on hold as I had to clear my area for several hurry-hurry-rush-rush projects. I'm doing my hands on stuff for this at my work space in my spare time - the spare time hasn't existed for a while and now my space has been cleared of my fun stuff and now I have other junk on it! One would think with sequestration a possibility that test and evaluation would suffer but we're busier than hell now.

I did use the HP 8903A to test some instrumentation channels for the 3dB roll off points for the frequency response of a few of our instrumentation telemetry signal conditioner circuits. I compared these numbers with our measurements using a spectrum analyizer and they tracked well. Just wanted to get more familiar with this test insturment.

One of our requirements is to measure the environmental flight conditions of a new drone that the navy will be using in the future. This data will be used to define the flight envelope and also for future payload electronics. We installed multiple accelerometers and other sensors to help define the this environment. Our first flight is not too far off - or so I'm told!! Too much fun.
Click to expand...


Dude!! I live for that kinda shit, you lucky dog!!!
 
I hope to get my bench back next week - a couple more boards to test and all should be good.
 
For the time spent you are expected to out quiet Joe and I......
 
laatsch55 said:
The other would be unobtanium expectations.....
Click to expand...

You just might be right - sometimes I forget that this is actually an audio forum.



Will the mods kick my ass - is this another 30 minutes one?
 
Last edited:
You must log in or register to reply here.
Back
Top