Peace Of Mind

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,948
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
#21
A 120 volt 60 amp circuit is not out of the realm of possibility and would only take #6 wire. However there is a more efficient way of getting the wattage that represents.
 

speakerman1

Honorary Forum "Larrt" (ornery too)
Joined
Jun 12, 2010
Messages
12,037
Location
OZONE ALLEY MARS (Visitor)
Tagline
Wasted Days and Wasted Nights
#22
laatsch55 said:
A 120 volt 60 amp circuit is not out of the realm of possibility and would only take #6 wire. However there is a more efficient way of getting the wattage that represents.
If you have 2 monos pulling 60 amps each that is 120 amps. You could not turn much on in a 200 amp service. I think he was confused. Yes you could do a 60 amp 120 circuit ; but why? Wouldn't be efficient at all. 14 is 15 amp, 12 is 20 amp, 10 is 30 amp, 8 would be 40 amp, 6 would be 50 amp, and 4 would be 60 amp. Service is usually 00 or is it 0000 on a 200 amp? I'm trying to remember how to figure conductors. You have to do the load plus a certain percentage. Which I can't remember.

larry
 

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,948
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
#23
There is a standard ormula for sizing house service but I can't recall it at the moment. There is a standard DERATING for more than 3 conductors in a conduit or cable. #6 copper in uf-55amps, #6 copper in THW/THWN-65 amps, #6 copper in SIS/THHn-75 amps. 3 ought in THHN woul be 225 amps capacity.
 

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,948
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
#24
#14 , #12, #10 have an NEC coded breaker size based on the lowest rated wire that can be run in a 120 volt branch circuit. #14 THHN is actually good for 25 amps, #12 THHN is good for 30 amps and #10 THHN is good for 40 amps. Insulation type and thickness plays a big part in ampacity ratings.
 

speakerman1

Honorary Forum "Larrt" (ornery too)
Joined
Jun 12, 2010
Messages
12,037
Location
OZONE ALLEY MARS (Visitor)
Tagline
Wasted Days and Wasted Nights
#25
I don't remember it. I was going by what I do remember. I was taught or the code was 12 does 20. 14 does 15. I very seldom did 14 ga. I never ran switches or lights on the outlet circuit. Just me. Why do 15 amps and depending what you are running on the circuit it will trip. Plus on a 20 amp I could put more outlets in the room. Somethings I'm anal about. Never wanted to get a call. The house you wired burn down. Just like GFIs if you have more than one use a CB. In the long run it will be cheaper. Yea I'm a little weird where some things are concerned. LOL

Larry
 
Top