Model ONE Build - S/N 0014

Whatever turns your crank is appropriate!! Whatever speakers you use, it seems more than any other component, they respond very well to clean.power and lots of it....i love em!!
 
Easier to stand the case on the side ,lid open to the right , grab a rack handle and a heatsink and slide it in....
 
laatsch55 said:
Easier to stand the case on the side ,lid open to the right , grab a rack handle and a heatsink and slide it in....
Click to expand...
I would be cautious supporting half the amp weight by the heat sinks. They are held in place by the output driver screws into the backplane PCB PEM nuts.

Probably not an issue if being very careful, but that is not a structural bolted joint in any form.
 
Hexis22 said:
I would be cautious supporting half the amp weight by the heat sinks. They are held in place by the output driver screws into the backplane PCB PEM nuts.

Probably not an issue if being very careful, but that is not a structural bolted joint in any form.
Click to expand...
Correct, handle it by the chassis, not the heatsinks. The screws that hold the heatsinks on are all the screws that secure the output transistors in place that have been carefully torqued so as not to damage the sil-pad insulators

Same warning is true for PL400 and PL700 amps
 
Ok thanks.

Are there any specs on these yet?
Kinda what I was I looking for?
 
You must log in or register to reply here.
Back
Top