Fuse holders

[Steve K]

I would like to replace the fuse holders and the RCA jacks on my 700b. I'm going to order some knobs from Antique Radio Supply and they also have fuse holders and jacks but I'm not sure if they would work. I'm trying not to pay shipping to two places but if I have to I will. Any thoughts?

 

[laatsch55]

Do they have a datasheet or dimensional drawing for them?

 

[laatsch55]

RCA jacks, Switchcraft # 3501 FRX...

 

[Steve K]

They do have data sheets, I just don't know how to post them.

 

[laatsch55]

Control C/ Control V works for me....

 

[Steve K]

Not sure if this works.

 

[laatsch55]

Yep, that worked...Let me measure some stuff....I do know you need 2 insulating washers on the RCA jacks...

 

[laatsch55]

The OD of the Switchcraft RCA jacks where they go through the insulating washers is .371


The OD of the fuseholders on the round part of the thread is .497, On the flat to the round thread OD is .462

 

[Steve K]

Thanks Lee, do you get those from Mouser and if so do you have a part # for both?

 

[laatsch55]

I got the rca Jacks from.Mouser. Got the fuse holders from Ed. Use the Switch craft number I posted above in your Mouser search.

 

[WOPL Sniffer]

The fuse holders are pretty robust and were actually of good quality. Do they NEED to be replaced? Even the old ones clean up nice with a little elbow grease and some chemicals (for the fuseholders, not you). Get all the old solder and flux off and they are as good as new.

 

[Steve K]

It's more a case of the knobs being worn out. There's not much there to get a good grip on. Can you buy just the knobs? This sure sounds like the making of a bad joke!

 

[grapplesaw]

I am using BUSSMANN HKP-CC 30A/250V FUSE CARTRIDGE HOLDERS i got off Ebay about $1 each. they take the AGC 1 1/4 long fuses but look like the original ones

10 lot here

http://www.ebay.com/itm/BUSSMANN-HKP-PANEL-MOUNT-HOLDER-FOR-3AG-LOT-OF-10PC-/182040349441?hash=item2a62734b01:g:Bn0AAOSwHnFV0OC6