Fishoz's PL 400 Conversion

We have a DC protect relay click and a good steady bias......install the rest of the outputs and back on the AP.
 
Never had a doubt Lee. I wouldn't even know where to start looking for a problem like that or have the patience or ability to find it. All I'm good for is popping a cover, cleaning the shit out, check for bulging caps and de-oxit everything.
 
All ouputs in, powers up fine, bias at .375 and holding steady, offset .001 and .000....the AP is warming up...
 
Frequency Response....


Residual noise....325 Microvolts--UNWEIGHTED....
 

Attachments

  • Frq Res, Graph.jpg
    Frq Res, Graph.jpg
    91 KB · Views: 15
  • Frq Res, Table.jpg
    Frq Res, Table.jpg
    102.4 KB · Views: 19
Thd & N , left channel...UNWEIGHTED....
 

Attachments

  • THD & N , graph.jpg
    THD & N , graph.jpg
    92.1 KB · Views: 16
  • THD & N , Table.jpg
    THD & N , Table.jpg
    97.2 KB · Views: 19
THD & N Right Channel....
 

Attachments

  • THD & N , Graph, Right.jpg
    THD & N , Graph, Right.jpg
    92 KB · Views: 15
  • THD & N , Table, Right.jpg
    THD & N , Table, Right.jpg
    98.2 KB · Views: 15
Max out was 258 wpc into 8 ohms, both loaded and driven at 1% distortion...
 
Signal to noise is KILLER!!! 102 db unweighted, 113 weighted...
 

Attachments

  • Other Measurements.jpg
    Other Measurements.jpg
    79.4 KB · Views: 18
Phaselag/lead then it goes on the horns for a SERIOUS shakedown...for a couple three days...
 
Phase lag/ lead Left channel
 

Attachments

  • Phase Lag , Lead, Left.jpg
    Phase Lag , Lead, Left.jpg
    91.8 KB · Views: 19
  • Phase Lag , Lead, Left , Table.jpg
    Phase Lag , Lead, Left , Table.jpg
    91.8 KB · Views: 21
And it's back on the horns....IMHO....the top end on the Rev E boards is sweeter....
 

Attachments

  • Other Measurements 139.jpg
    Other Measurements 139.jpg
    98.3 KB · Views: 46
Did you blow her up yet???

The only thing I don't want to hear is that you're keeping her.
 
Back
Top