docdan's Phase Linear 400 White Oak Conversion

Very easy to do, just gotta pop the top and everythig you have to get to is right there...
 
Very easy to do, just gotta pop the top and everythig you have to get to is right there...
Arriived safely I won't be able to get to it till the weekend. Thank goodness it's a three day. I've been under the weather and we have a houseful of relatives who leave on sat.
 
WOW... I couldn't stand that... That would be tough not hooking it up NOW !!!!!!!! Good luck with it... your in for a treat !
 
Talk about having an itch to scratch! :jerk:
nice to have something to look forward too when everything calms down. Turns out I have diverticulitis and that's why I have a pain in the gut. I thought it was referred pain from the ass of having all the relatives around.
 
securedownload.jpgOkay I have popped the top and need instructions on setting the bias. also looks like a part came loose in transit. Looks like a relay that needs to plug in somewhere.
 
Last edited:
That's the dc protect relay. The relay plugs into a socket on the board located where your outputs are.
 
Shame on these folks for not helping you. The bride and I took a bar break with a hand from the shop. But we're back.


Dan, you will notice in the top left hand corner of the DRIVER BOARD a small hole labeled "Bias". Positive lead goes there. Negative lead on the positive speaker post of that channel. Turn amp on and adjust little blue pot to 350millivolts DC. Do that to the other channel by moving positive lead to the bias test point in the top middle of the DRIVER BOARD, and hegative lead to the positive speaker post. Adjust to 350 ike the first one. Let warm up for 15 minutes adjust both to 385 MV this time and you are done. Let er rip after that!!
 
Shame on these folks for not helping you. The bride and I took a bar break with a hand from the shop. But we're back.


Dan, you will notice in the top left hand corner of the DRIVER BOARD a small hole labeled "Bias". Positive lead goes there. Negative lead on the positive speaker post of that channel. Turn amp on and adjust little blue pot to 350millivolts DC. Do that to the other channel by moving positive lead to the bias test point in the top middle of the DRIVER BOARD, and hegative lead to the positive speaker post. Adjust to 350 ike the first one. Let warm up for 15 minutes adjust both to 385 MV this time and you are done. Let er rip after that!!

Sorry...digging footings and pouring cement before dark descended on me.
 
Just giggin ya Joe. Jan and I went to the bar for awhile with a coworker.. What's up Dan??
 
Sorry...digging footings and pouring cement before dark descended on me.

Damn, sounds like work.... BIG lightning and thunder storm out here right now. Hope it clears out, gotta date to watch the meteor shower tonight....
 
Aye Cap'n...we've lost another to the WOPL i'm afeared....
 
Back
Top