docdan's Phase Linear 400 White Oak Conversion

[NavLinear]

That is a different looking set of meters Lee. Must have been Friday afternoon on the production line at PL

Or after lunch! Are the dimensions different?

 

[laatsch55]

i never measured one.......

 

[laatsch55]

Getting the faceplate on and then it will put on the AP, may be some interesting measurements on this one..

 

[Skynyrd77]

Gettin close now!! Got to be the best part. Firing it up for the first time. Or the scariest part lol

 

[laatsch55]

Been listening to it for 5 days, excellent sounding little 400...

 

[Skynyrd77]

Been listening to it for 5 days, excellent sounding little 400...

Ok lol forget all I just said. If youvr been listening to it for 5 days. So many build threads so little brain cells!!!

 

[docdan60]

Been listening to it for 5 days, excellent sounding little 400...

Oh boy. Oh boy. Oh boy

 

[laatsch55]

Ok lol forget all I just said. If youvr been listening to it for 5 days. So many build threads so little brain cells!!!

Welcome to my world!!

 

[laatsch55]

Oh boy. Oh boy. Oh boy

I agree this is a sweetie, even the Pig quit snickering after the first day...

 

[laatsch55]

Checked it Joe, and you were right, not that I would not have noticed it, but it's quite possible it may have been powered up when I noticed!! Flipped the deluxe model 2 cap holder around, I now have at least1/16 clearance....

 

[Gepetto]

Checked it Joe, and you were right, not that I would not have noticed it, but it's quite possible it may have been powered up when I noticed!! Flipped the deluxe model 2 cap holder around, I now have at least1/16 clearance....

You were probably wondering what that extra hole was there for

 

[laatsch55]

Well........maybe.....a wee bit......kinda.....sorta.....

 

[laatsch55]

Testing....1,2,3.....testing...

 

[laatsch55]

Frequency response.....now

 

[laatsch55]

Residual noise...

 

[laatsch55]

IF----someone had taken the faceplate loose and not been aware of the clearance there is enough slack in the faceplate holes to cause the meter positive post to touch the cap hold down plate. A small relief channel will take care of any fit tolerance on the faceplate....

 

[laatsch55]

Joe, any problem just leaving the jumper off, iffy in both places for a max out test...

 

[Gepetto]

Joe, any problem just leaving the jumper off, iffy in both places for a max out test...

No issue Lee

 

[laatsch55]

K.. thank you Sir...

 

[laatsch55]

Once again, world class SNR-----max out at 1% distortion...