Ben's (BubbaH's) Phase Linear 400 WOPL conversion

No problem here bud. Take your time man. Theres an old saying about rushing stuff, but I dont remember it. :wink:
 
Got my order of new speaker posts and RCA jacks in too....YA!!!!
 

Attachments

  • SAM_1057.jpg
    SAM_1057.jpg
    96.4 KB · Views: 44
80 volt caps?

Ben's is next. ......It's getting the Rev "D" driver board, Rev "B" backplanes, LED light board, Don's DCP, 18,000uf/80volt Cornell-Dubilier PScaps, MJ21195's and 96 outputs.....pretty much everything we can do...

Lee, I thought the WOPL's needed 100 volt caps?
 
They do, this one has Joe's 100 volt cap stacks... The only 80 volt I use are the old stock Ed sends me once in awhile. He had a stash of 80 volt CD's that I'm confident can stand the push, but he's about out. Remember I'm the guy that runs those 100volt/22,000uf's in my personal 700's.....
 
They do, this one has Joe's 100 volt cap stacks... The only 80 volt I use are the old stock Ed sends me once in awhile. He had a stash of 80 volt CD's that I'm confident can stand the push, but he's about out. Remember I'm the guy that runs those 100volt/22,000uf's in my personal 700's.....

Lee always lives on the edge...we know that :-)
 
Plus, I doubt I'll even restore enough Spec 2's to burn up my stock of those 100volt/22k caps. I think I bought 30 of em...course a Spec 2 takes 4 of em...
 
Cap hold down fabbed.....
 

Attachments

  • SAM_1058.jpg
    SAM_1058.jpg
    91.4 KB · Views: 56
Got a few hours today while 2 of our workover rigs are moving to different loactions so we are wiring up the backplanes..
 

Attachments

  • SAM_1059.jpg
    SAM_1059.jpg
    100.7 KB · Views: 34
Left board done...
 

Attachments

  • SAM_1060.jpg
    SAM_1060.jpg
    98.2 KB · Views: 30
Boards wired.....
 

Attachments

  • SAM_1061.jpg
    SAM_1061.jpg
    102.8 KB · Views: 31
Whats the rail voltage on a 400, 75v? If so, an 80v cap ought to work, though it is a bit tight. The stock 700 rails were at or a couple volts over their caps too. I think mine runs like 103v and the caps are 100v rated.
 
Back
Top