So I unsoldered the balance pot off the board, it has 3 pins..
center pin to L is 3ohm when turned L.
Center pin to R is 2 ohm when turned R
on the board, center pin is grounded.
When turned full L or R, the resistor doesn’t smoke.
Under 25% volume pot all is good…
Above 25% volume pot problem starts.
center pin to L is 3ohm when turned L.
Center pin to R is 2 ohm when turned R
on the board, center pin is grounded.
When turned full L or R, the resistor doesn’t smoke.
Under 25% volume pot all is good…
Above 25% volume pot problem starts.
Last edited: