Thanks Don for a wonderful product. Your DCP board protected my subwoofer.
I was adjusting my active sub crossover when the speaker gave a couple little burps then....silence.
Power reset, try again. Burp...silence.
Power reset.....silence.
I pulled the amp, checked fuses. Both rail fuses were blown. Put it on the bench and checked power supply...good
Installed new rail fuses. Brought it up on the DBT. All is good.
Gave it some signal...good. so what happened?
Seems the crossover has an issue. Left channel level adjust pot is putting as much as 2 vdc on the input of the amp intermittently. Gonna have to find out why.
Thanks again Don, this could have been worse.
I was adjusting my active sub crossover when the speaker gave a couple little burps then....silence.
Power reset, try again. Burp...silence.
Power reset.....silence.
I pulled the amp, checked fuses. Both rail fuses were blown. Put it on the bench and checked power supply...good
Installed new rail fuses. Brought it up on the DBT. All is good.
Gave it some signal...good. so what happened?
Seems the crossover has an issue. Left channel level adjust pot is putting as much as 2 vdc on the input of the amp intermittently. Gonna have to find out why.
Thanks again Don, this could have been worse.
