Question Sir Joe

laatsch55

laatsch55

Administrator,
Staff member
#22
Joined
Jan 14, 2011
Messages
74,244
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
#22
Supposed to be a good sub anyway. I have to transfer 2 pieces, the power supply harness and that opto sensor. I should pre-tin the spots where the gull wings go correct? And the gull wings? Surface mount is new to me...
 
Gepetto

Gepetto

Administrator
Staff member
#23
Joined
May 15, 2011
Messages
13,553
Location
Sterling, MA
Tagline
Old 'Arn Enthusiast
#23
laatsch55 said:
Supposed to be a good sub anyway. I have to transfer 2 pieces, the power supply harness and that opto sensor. I should pre-tin the spots where the gull wings go correct? And the gull wings? Surface mount is new to me...
Click to expand...
yes SMT versions Lee. Pre tin the pads and then solder wick them. Then apply the connector and some more solder
 
You must log in or register to reply here.
Top