PL 400 Series One Fuse holder replacement

Sunnbobb

Sunnbobb

Journeyman
Joined
May 25, 2023
Messages
255
Location
Mount Vernon, WA
Tagline
Bikes, baseball and big amps.
My 400 has three different fuse holders.. I searched the site and the net for information on a proper replacement part. I'd like the holders to match and be original if possible. Anybody have a suggestion? I appreciate it.
 

Attachments

  • fuse.jpg
    fuse.jpg
    845.1 KB · Views: 9
Sunnbobb said:
Thanks, exactly what I needed. You're a good man Charlie Brown.
Click to expand...

Don't tell anybody, I might get a bad name.

I buy those holders by the 100's since I replace every single one on every amp I have done and these are great hevy dooty stuuf.
 
I bought several hundred and am down to 4 holders left. I ran out of stash for all my parts so I retired.
 
Although they appear to be parts made after production moved to Mexico, the tabs are different from older components I've had for over 10 years.

Left is new just received from Future Electronics, Right is old:

IMG_E6238-X3.jpg
 
Looks like they chinee'd out a bit but still should be excellent replacements. The new style tabs are for either spade terminals or wire so no problem there. Looks like the 16ga wire should go in there easily. I have used these before.
 
Funny, I didn't realize that they have a store on the south side of the Twin Cities.

They also carry the solder style with tab's like your older ones.
 
The smaller hole would require modification for use in attaching multiple 16ga wires as used in 400 builds.
 
I ordered the replacements, thanks gang. As A side note, I also sent emails to WO and WA for parts to get the rebuild underway. Looks like "robyn" put this one together originally..
 

Attachments

  • 20230531_105610.jpg
    20230531_105610.jpg
    1 MB · Views: 8
Last edited:
You must log in or register to reply here.
Back
Top