Search results

I think it is because it is just a sad and unbefitting end for a once great company Tony...

I am sure Highlander was thrilled to unload those turkeys...when you are run by private equity, you are on death's door.

The backplanes have top half and bottom half test points which should show nearly equal but opposite polarity bias readings. The control board only has a test point for the positive top half which is the same as the backplane top half

I'll say...

I can tell that he likes you Chris...

Nice seeing one with the good knobs on the front...

Install Don Imlay's triac based product...

Hi Rob We have a wanker here in MA as well. My sympathies...

When less is more...

And if and when you do that, remove the ground bus wire on the back side of the board assembly. The separate ground wire from 5R to the bus bar will serve that purpose. Leave the 2 upper power bus wires in place however. Just the lower ground bus wire.

It is a PDF Lee, no cheaters needed, just zoom in on the document as I did to get you this snippet

Yes, that is what it says in the middle of each device on the diagram...

I have just about everything Lee. Pretty sure that I know as much about PL 400/700 amps as the founder did/does. I documented a lot more.

The attached should be clear enough Lee...

Water off a duck's back...

Yup, brushless permanent magnet DC motors...

The USPS infrequently will end up bouncing around erroneously. No service is perfect. The agency has majorly improved services over the last several years and has become quite reliable for USA deliveries. I ship a lot and use them pretty exclusively. I do not use them for Intenational...

Home Depot special...

Lets focus on the green wires to the fuseholder which is the B+ supply (the blue fuseholder is identically wired for the B-). One fat green wire and 2 smaller wires go to the fuseholder tip. The fat one is the B+ from the bulk cap. The smaller ones are the feeder wires to the unfused B+ that...