Search results

Nah, I set my upper limit and was aced on everything.. grrrr. Oh well, It was an amazing bunch of stuff, and with the dust and dirt on the gear, it was difficult to tell exactly what condition the stuff was in.

Ah! Now I know who outbid me on the Port Orchard auction! LOL

I found a TS100 soldering iron does everything I need. I swap out a pointed and flat tip depending on the job. Takes about 10 seconds. I also use Kester 44 .031 solder, and Kester 959 soldering flux. It takes less than 10' of solder to complete a wopl. A 3oz bottle of flux may last a lifetime...

Hi Joe, pleased to report the amp operates perfectly. And odd note, when I first fired it up with music at about 85db, I had a "ghost signal" showing on the right LED meter together with some mild clipping. After about a minute, it went away, and has not returned. I should get a scope some day...

Phase Linear Autocorrelator Model 1000 Series Two

Hi Joe, sorry I had to take a break for other things, and I just finished buttoning it up. Onward to real speaker testing. No fires or booms so far! Thanks so much for the guidance.

"Non tutti i motivi sono uguali" I swear that is from the Benelli service guide!

"Not all grounds are created equal" Boy, that sounds like you have been hanging out in my shop working on Italian Motorcycle wiring! Thanks for the tips boss. I really appreciate it.

One last question. Can i run r2 and l2 from the copper bar, rather than all the way back to the pots, since pot post 3 (ground) already runs to the copper bar?

Alrighty then! rolling up my sleeves and going in. lol

Should I be running a new wire between the copper plate and the bus, or will the inputs get their ground through 2l and 2r connections?

Wow, I'm not worthy! That fixed the output voltage and output relay issue. Output voltage is pretty much zero. thankyou thankyou. Now my ears are open with the input arrangement.

Here ya go. LMK if you need other views, thanks!

will do,thx!

Joe, the first picture in the thread is this board.

Joe, vdc, thx

Laatsch, DC Offset (J1-1 & J2-1 on WA Output Relay) L .7V R .7V

Dianne, the series II 400, is being a spoiled Princess. It has an issue. Firing it up, everything goes as planned. Then, after about 20 seconds of idling, The Output relay shuts down. If I try a restart, the Relay lights up for a brief moment and does not energize. If I wait an hour or so, I'm...

Thanks again, I had them wrong. The missing pnp's on the diagram messed with me. I should have seen that. I think I have it right. Glad I asked and you responded before I powered up.

Thank you!!