mlucitt's latest activity

The Bias reading will probably not change much, now that you have two rows of Output Transistors installed. The real Bias check is after...

You're getting close...........you will be making incredible music soon ! :D

Yes, the caps will discharge. As Mark mentioned that he does, I also use a 200 Ohm 5W bleeder resistor and (2) small alligator clamps...

I install the thin Nylon washers under the Control Board and under the two Retaining Nuts because I have to remove/replace the Control...

Is this amplifier quasi complimentary or full complimentary? Quasi complimentary will have all NPN outputs such as MJ15024, TP9054, or...

Yes, because there is a discharge path now through the "Fused" and "Unfused" rails. However, I always measure or just install a 200 Ohm...

Joe is generous with the wire lengths going from the Backplane Boards to the Control Board to make sure you have enough. You can...

An uneventful power up is good...........did real good bud....

According to Joe at White Oak Audio Design, https://www.whiteoakaudio.com/estore.aspx It used to be a good idea to match the hFE, or...

Welcome to the best audio forum on the Internet!

Yes, and I read all the manuals and if I still had questions, I then asked for help. Help is one thing, doing all for you is another.

OK, Send me the invoice, I have the additional parts already so it will not be too painful. I will let the customer pay me in three...

Sure I'll bite. Maybe Joe will give me an allowance for a review here after the installation of the new Meters and Faceplate...

I know we all get tired of reading these type of posts, but... Having checked all the usual sources, eBay, Craigslist, Audio Mart...

We appreciate you stepping out and trying....good man!!