Damn your good :
R6 in my case is comprised of a 200K and 30K in series for some reason. An in circuit test showed up as open, turned out to be the 200K however, when I pulled them from the board, one of the pads was lifted but he 2 resistors now tested fine
![S-confused2- :confused2: :confused2:](https://forums.phxaudiotape.com/smilies/confused2.gif)
I put them back in and fired up the amp, .023 on the output
![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Can a resistor behave that way? I wish I knew if the problem was the resistor or the pad.
I have some 220k on hand, should I go ahead and replace the series combo??