Wanted guidance

[orange]

guidance, belts or tires so i can't get a reall clean and nicw CT-F2121 I got last year. it seems they tend to bad TIRES and i tried tearing one dow a few years ago to no avail and it sits in a box.

Too cute to sit, that's why I got it.

 

[rtp_burnsville]

Take lots of digital photos when taking it apart... They will be very helpful when putting it back together. I always remember to do that just about the time I get something all apart.

Always start with a clean work area so you can easily find that one small part you will drop! A roll of white drafting paper makes a nice cover for the bench and helps one find those mis-placed parts.

Now do as I say and not as I do....

Robert

 

[orange]

That's a good thing but I about massacreed the first pne and never did find {"TIRES") that I know exist anwere supposed to be stopping it dead.

It worked to some degree when I got it, they are fun little boogers too.

Maybe I should photograph the $6 Million Yen victim.

 

[orange]

I'll open it later tonight to take photos. iI can't leave it ope a lot, too much cleaning and moving stuff.

 

[orange]

Still here....bringing oit out back with the Kenwood so it does 4.0 with the Hitachi for now.

 

[Web Police]

Keep on the straight and narrow and always wear clean underwear.

 

[orange]

I forgot....[attachment=2:396v13qd]MVC-009S.JPG[/attachment:396v13qd][attachment=1:396v13qd]MVC-010S.JPG[/attachment:396v13qd][attachment=0:396v13qd]MVC-013S.JPG[/attachment:396v13qd]

The belts appear intact, Nothing moves, especially the counter.

 

[orange]

I had the shots but spent a good part of the day looking for a new vacuum cleaner. I clean/fix the ungodly Bissell more than I tend to use it ndI have lost THREE BELTS ib rgwe last six months. After a thorough inspection cleanup, whacking HAIRBALLS out abd I think the moter is going not the belt...

If it were a hooker it would be finding a new job.

Hope to have one tomorrow.

I have to go reattach the rear fender on the Schwinn as well.

 

[rtp_burnsville]

Hi,

If nothing moves it sounds like something with the motor or motor controls/logic. I read that your deck uses some sort of servo logic to detect end of tape, could be something wrong with a sensor. Here is a link for a free schematic:

http://elektrotanya.com/?q=showresult&w ... =&kat2=all

Robert

 

[orange]

There's not much logic in a deck built before 1975 maybe.

This is that deck:

Not MY deck, the wood would be pretty nice...and here's an internal view!

 

[speakerman1]

If meter no turn. Then tape is done. Do any motors spin? Try deoxing them and spin by hand. You may be able to get a tire on ebay.

Larry

 

[orange]

I do have the entire SM that I bought a few years ago on CD.

This is the one motor I've seen so far...[attachment=1:2gsypn06]MVC-009S.JPG[/attachment:2gsypn06][attachment=0:2gsypn06]MVC-010S.JPG[/attachment:2gsypn06]

10 is to show the belt is there and seems intact.