testing the +20, -20 volt regulatorsa on the White Oak board

laatsch55

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
75,469
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
From Joe on a previous post;

Connect the negative DMM lead to star point ground in your amp.

Plus 20V measurement
Connect your positive DMM lead to the top side of R73R, just to the right of the TO-220 transistor Q30. It is a 10 ohm, 1/4W resistor. This should measure +19.0 to +21.0V if operating properly in your amp.

Minus 20V measurement
Connect your positive DMM lead to the top side of R80, a large 2W resistor just above the board lower mounting stud. It is a 12K ohm, 2W resistor. This should measure -19.0 to -21.0V if operating properly in your amp.
 
Re: testing the +20, -20 volt regulatorsa on the White Oak b

Thank for posting this Lee.
 
Re: testing the +20, -20 volt regulatorsa on the White Oak b

Missing some wattage eh??
 
Re: testing the +20, -20 volt regulatorsa on the White Oak b

You could send the ti's to me and i'd see if they could handle it!
 
Re: testing the +20, -20 volt regulatorsa on the White Oak b

laatsch55 said:
You could send the ti's to me and i'd see if they could handle it!
Click to expand...


I'm pretty sure they could take it ;) Bring one down to Vegas. You can go out on the town for the wekend and I'll check out the amp :blob7:

I was gonna sell them since I got the Alon's but have decided to keep them for now. A WOPL 1000 may be just what they need........
 
Re: testing the +20, -20 volt regulatorsa on the White Oak b

Ya want one just to audition??
 
Re: testing the +20, -20 volt regulatorsa on the White Oak b

I thought the Alons went to the curb??
 
You must log in or register to reply here.
Back
Top