Gear

[speakerman1]

I have several acct.s with different companies. Parts Express, Tara Labs, Music Hall, Sanus and some I don't remember off the top of my head. If you need anything let me know. I have never charged MSRP. On some thing I make no profit I sell what I buy it for. There are things I can get that if you don't ask you will never know. So just keep that in mind before you buy things. Even on ebay I may be able to get things cheaper than what they are selling on ebay. So just thought I would offer. I did in another forum as well. Just rying to help.

Larry

 

[orange]

Sooner or later I'm going to figure out the crossovers and get the good vinyl covering and grille material, etc to finish my PA/DJ speakers but I'm broke at the moment, need laundry and dish soap and two medicine co-payments.

I might be able to adjust the crossovers I have, they are two-ways branded "Herald" I bought a few years ago on eBay (I have three and two have a loose transformer) I have some insulation batts to line the cabinets but I know that won't likely be enough to make up for the bass crossover point being seemingly too high, leaving low frequency response poor. I do have the wiring correct. Because the horns (Magnavox alnico) are goining in the old port that served them when Electro-Voice coaxials once populated them (I was told but I got them empty. I have those 150W plus 12" Pioneer PA speakers that PE discontinued a few years ago.

Great Plains Audio has horn bodies for about 24 each but the diaphragms and drivers are out of reach. I can't use 511's I think it was as I don't have room, even angled. I have to use the drivers meant for small necks?

In time...

 

[speakerman1]

If you give me your xover points I can probably design some nice xovers for you. Those are inductors not transformers in your xover.

Larry

 

[orange]

http://www.parts-express.com/pe/showdet ... er=290-142

Those are the woofers. I'd like to use the pads I have for the panel and brightness control.