- Joined
- Jul 6, 2010
- Messages
- 17,704
- Tagline
- Broken beyond repair but highly affable
I had to find the grounding problem on a belt drive Panasonic clone, MCS Digital 5000 Series table, found the wire was not connected to whatever it was supposed to go to...
Spliced a long length of wire to it with a heat shrink sleeve (thank you Lee) and attached a spade connector to it. Had to replace a foot. Bought a needle from Needledaddy on eBay via a friend. Cut a foam pad for it to absorb shocks.
Ready to deliver now.
Spliced a long length of wire to it with a heat shrink sleeve (thank you Lee) and attached a spade connector to it. Had to replace a foot. Bought a needle from Needledaddy on eBay via a friend. Cut a foam pad for it to absorb shocks.
Ready to deliver now.
Last edited: