Search results

yup…for some reason I couldn’t see the pictures in the first post. Very nice.

Very nice looking speakers.

Which Infinity's ????

Persistence pays, well done. Going to be a really nice table Jim.

Filled up with Diesel yesterday $4.40 ($4.39.9 to be exact) and that's Texas, going to be worse for the tree hugging states. Hang on to your boots boys, this is going to be bad.

Congratulations and welcome aboard. Your first PL amp ?

Nothing for a PL cowboy like you Lee, a little elbow grease, some WO parts and they would be better than new.

Well I can’t argue with that……how about the center of center, out of phase of course.

Yup, going to fit right in ^^^^ lol. Welcome to the center of the Phase Linear universe.

Wonder what ever became of these, hopefully someone got them going ?

If I am following along correctly, you did not verify operation prior to changing the caps?

Insight into the mind of an engineer right there ^^^^^^^^^^

Might be better to attach the heatsink with a piece of bare wire twisted around the sink and resistor. JB Weld may insulate between the two and possibly cause the resistor to run even hotter.

Thanks George, that is similar but unfortunately the connector on mine is down in the tube and heavily glued. I have some de-bonding stuff that I am going to try but confidence is low that it will work. If I could figure out how the arm tube attaches to the main body then i could push it out...

The wire in both of my arms is copper and I had originally planned on replacing it but have two problems. First the stand alone arm has a female plug at the headshell end that I can’t get out without destroying it and the second is that since these use a torsion bar design for setting the...

Let’s just say I get Christmas cards from Wiha every year.

A gift from my love, she says I am hard to shop for because I am like a ten year old with a credit card…..lol, so true.

Judging from the pictures your arm seems to be far more sophisticated and more solidly built than the 707. Granted my examples are in rough condition but as far as quality of materials I was far more impressed with some of the Sony arms I have taken apart.

Personally I like it without the clear, I would also be concerned that in time the clear would start to peel. Vinyl will offgas over time, they do make “plastic” spray paint but there are hundreds of vinyl formulations so longevity could still be an issue.

Should have taken more pictures but there are differences between the one that came on the TT and the stand alone unit. Nothing major but the main bearing housings are slightly different, one is in a brass sleeve and the other a chromed brass sleeve, the chromed sleeve places the bearings...