Search results

"The Gray Bit You Push On"? Are you going to require Over Seas Shipping? Pull one off one of the other switches and get some pics posted. There were a couple different caps used and you may have to paint the replacement. Post good pics or we won't be able to match them up.

I used PunkerX. He only had 1 unit ahead of me. Not backed up at all.

I sent my Tuner out for alignment about a month ago and it is finished and on the way back to me. I did a recap and a cleanup before I shipped it, and between the recap and the alignment, she should be good to go. It was in great shape when I bought it and outside of changing to LED's for the...

Did you have any of the Ivars Clam Chowder??? The best..............

Hope you got unwound and kicked back with a nice tall Scotch..... Now get crackin' :)

Damn, it took 50 years for the burns to get him??? He was a tough SOB..... Just kidding. RIP Ronnie.

Can't bro...... It's proprietary.................... :)

I'm with you Marco...... I'm in it for the PROPAGANGA................ You'll never smoke anything else after some propaganga..........

The 200ohm resistor and the 36kohm resistors on Main 1 Are the resistors we use to change the gain. Look at the C1 Service Bulletin. You can only change the gain on main 1. You can read the SB if you are so inclined. Main 2 does not change. So, main 2 has the 200 ohm but no place for the 36K...

Comparing the C-1 to the Acurus, the Acurus has both Pre-Out Jacks wired exactly the same. Not so on the C-1 jacks. I'll have to look at the C-4000 and the 4000t but I think the circuit will be the same as the C-1. If I wasn't Vertical Bi-Amping The C-1 would be fine. The Output impedance...

The Acurus drives 2 amps no problem. The Martin Logans also say DO NOT USE ACTIVE crossovers as these cannot be Bypassed.

I know when we change the Gain on the pre, it only changes the gain for Main 1 and it doesn't change Main 2.

The book says you can use EITHER but it doesn't say you can use both at once.

All new coupling caps.

The headphones sound great.

Yeah, both outputs (so both amps) sound bad. What about the 2 pairs of transistors on the outputs at Main 2? Q205 and 305??

Has anybody tried this ??? Have you ever tried to run 2 amps with a c-1? I think since I'm running my speakers with my 400 WOPL on the L/R tweeters and mids, and I'm running my 700 WOPL on the L/R woofers (Horizontal Passive Bi-amping), that the main out 1 and 2 are not set up right to be...

Buy Sell trade.........

Your Chemical does what????

Don't forget the Chee-Hua-Hua