Search results

Main 1 and Main 2 originate from the same op amp output, Main 1 goes through a 200 ohm series resistor to the output with a 36K resistor to ground after the 200 ohm resistor. The Main 2 output is the same with a 200 ohm series resistor but no 36K resistor to ground. Are both outputs distorted...

Very welcoming...

Sent

PM me your email and I will send over details Joe

Kinda like this forum :-)

Do you have a Series 1 Lee?

She is what made the show...

I have been noticing that in a couple of pics posted recently how bright they are. They have a version below that are not retina burners...

I think I should spec in lower intensity LEDs...

I am working on bringing back a set of AR3s now. Designed a replacement crossover that I will be offering soon. Biggest part of the task was sourcing the 16R rheostats used in the crossover to replace the useless, original Aetna-Pollak ones that always fail.

Maybe Ed is "Phasing" back in... :-)

Great looking amp Doug, and great looking on the inside too due to your excellent workmanship...

I guess it was really one last time. RIP Ozzy

Where was this toggle switch and how could it make that happen Doug? Glad you are back in business...

Doug, check under the hold down plate to ensure you do not have a pinched wire or something like that going on.

The main caps are installed with correct polarity based on the photos.

And none of the smaller fuses?

The procedure is on the BOM, at the end

The way Bob wanted it to look…