Search results

Outputs in, boards cleaned, just ran thru some testing of outputs soldered in with Lee.

Gathering supplies for dim bulb tester, bulbs are hard to find, got one on order. Just need dual power socket with switch and sil pads. Got a couple of outputs on order from mouser. There will be a wait on parts, just have to be patient. Some good reference material there :evil4:

Mostly 70's and 80's mix tapes so far. DBX Encoded. Some or all? recorded from vinyl. Some good stuff on there.

No worries Lee, have a good rest.

DBT needs small clamps on the positive and negative right?

yeah all the practice helps bud. So lucky for DC protect. The outputs got easier to remove 2nd go. No magnet either.

No DBT here. But yea will use variac. Thank you for your time bud, its great to get some clarity and a solution

So outputs can just go even if not stressed all the time?

Ok will clean the boards up also

Once I have replaced that output, and sil pads, do I bring it up on the variac?

By the way, I believe if a fuse blows, its best to investigate, not just replace, they blow for a reason :evil4 Main power fuse I can understand, replaced one of those from turn on fatigue.

Got spare fuses, will chase up outputs and sil pads

No sil pads but old ones seem ok

Assuming the to220s go bce left to right: To220 bottom left B- to E+ 1490 B- to C+ no value E- to C+ no value B+ to E- 584 B+ to C- 584 E+ to C- 491 To220 bottom right B- to E+ 577 B- to C+ 575 E- to C+ 753 B+ to E- 1520 B+ to C- no value E+ to C- no value

To clarify, to220s pins down writing towards you, B,C,E pins in that order?

No bell on the 10.7

Are we still on backplanes or have we moved to control board?

All sockets measure 10.7 except very bottom one which is 180

Thats on diode setting, do you want ohms?

All sockets B to E cause meter to beep and show value of 15 except very bottom one which does not beep and shows 211