Recent content by v65magna

Hi everyone I’m having a trouble with my Akai Gx-77 seems the tape counter is not working sometimes ,I see from forums that there is a little plastic paddle that operates the counter , is that paddle supposed to spin freely , my deck will shut off after a couple seconds in play or ff rew when...

Hi Marco , hope all Is well , what temperature should I put my soldering iron on when I install those inputs,, just want to make sure I don’t damage nothing , thanks Peter Canada

Marco I got those rca inputs the other day I want to thank u again for sending them , that was so nice of u to do that ,, I appreciate it big time ,, thanks my friend

Ya that’s what I thinking also ,, thanks my friend for taking time and helping me out

I’ll just crimp them , no solder , ,, will that be fine ,, and again thanks for your replies much appreciated

I got theses forks , good for 12 gauge wire,, I’ll solder the wire in to these , they are not gold ,will that compromise the sound thanks Peter

Thanks for helping me out I appreciate it ,,Where would I purchase these pins , , I wonder y watts abundant kit didn’t come with bigger insert holes on the binding posts , the hole on the new binding posts are a lot smaller , would of solved everything if the holes were the same as the original...

They all have that nylon insulator on all the posts they are just defferent colours

Hello everyone hope all is well , my question is I stalled the watts abundant speaker board ,, but it seems the holes on the speaker binding posts are a lot smaller than the original posts, I cannot insert my 12 gauge speaker wire into the holes , no way they are going in , is there some of...

Thanks again those bulbs work perfect

Thank u

Hello everyone I like to thank all the members on here for all the help in helping me install the phase linear 700 b speaker protection board from watts abundant, everything works good , I have another question there’s 3 sockets on the front panel where 3 bulbs are , when I had the front cover...

Thanks lee for all your advice , I hooked it up everything is working fine I’m so happy just the left channel volume output has to be cleanel it’s a little scratchy always has been I order some detoxit d5 and detoxit feather lube , just waiting for them to get here , thanks again , I love the...

I hope I did everything correct I’m pretty sure I did , lee that solid wire don mentioned to cut , see pic where I cut I soldered the white wire to where the end of cut was ,u see there’s a wire still attached to it from the factory I left it alone , is that correct here a few pics

Hi lee I just finished , took me couple hours , hardest was soldering those Ac wires to thr reftifier , but I got them on ,, cut that solid wire like don said in his procedure soldered another white wire to ground off the neg input jack as dons instructions , twisted it with the other 2 wires...