Oldskoolfan's latest activity

You can do it with an active inverter as well - no need for a transformer. Most amps that support bridging internally use a simple...

The transformer is an option i've explored but to do both channels would require 2 amps and 2 transformers ... I think... :munky2: I was...

This as far as I could get for now.. Ordered some 2 hole ground lugs for the caps. Should be here this week sometime. Gives me time to...

That 470uf, 100v cap seems...large as a replacement upgrade for C6, a 100uf, 6.3v cap. What say ye? I have smaller. Help!

Yes

Just to be clear, the diodes are paralleled across C6, cathode to anode?

Yes, bias is good. Both trimmers are at about 60% of travel. Bias is more stable as well. Has about +/- .1 millivolt after stabilizing...

Joe, are the diodes installed anode to anode or cathode to cathode across C6?

Well, I ordered the 470uf caps and the 1N4148 diodes. I started reading through the tips and archives. Discovered people are...

Got a pic of how you installed the diodes? Not a lot of room on the back of the board.

My translation of that quote is "never do a bad job good"

The link above no longer works. I found a new link: http://ijfritz.byethost4.com/MiscProj/transmat001.pdf?i=1 and an archived copy at...

The diodes prevent the early board design from going into latch up.

This is the mod to prevent the amp from going into oscillation? I remember reading about this.

You should change C6 to 470uf and put back to back diodes across it 1n4148