F/S. Phase linear D-500 and Carver C-4000

grapplesaw

Veteran and General Yakker
Joined
Aug 13, 2014
Messages
2,762
Location
Vancouver
Tagline
---
#1
Here is a fine pair.
The D-500 is a late modle which has nbeen well checked over. It has had newer power caps installed with a new 50 amp bridge rectifier. The control board has been upgraded to the lf351 opamps with 7.5k dropping resistors. As well the output pairs are new with other new resistors as required to get in speck. Full output at 520 watts into 8 ohms Dc offset is 4mv left and .45 mv on right. Bias set to .350 volt on high rail voltage

The Carver C-4000 has been upgraded to new electronic caps. Bipolar through the signal path. It has upgraded opa2134’s in the main amplifier section.

So here it is folks, and Steven, only $3,000 USD plus shipping for the pair

Very clean original pieces.

PM me if interested
 

Attachments

Last edited:

laatsch55

Administrator,
Staff member
Joined
Jan 14, 2011
Messages
74,124
Location
Gillette, Wyo.
Tagline
Halfbiass...Electron Herder and Backass Woof
#7
I've never seen the score mark on them before.....never been that close I guess...
 

grapplesaw

Veteran and General Yakker
Joined
Aug 13, 2014
Messages
2,762
Location
Vancouver
Tagline
---
#9
I have been run off my feet so sorry I have not got back to everyone who has sent me a PM

(Thanks Perry that was a special thought you sent)

Come on people this is the Best of the Best

You know you gotta have one. I just don’t need so many
 
Top