Recent content by LarryD

front and back

Pic of amp w/drivers and My trick install extended Allen wrench and Vacumm chuck to install and remove the outputs. No more fumbling with them.

Lee, the drivers are at the bottom of each row. I do not understand ?

I just saw your markings on the connectors, sorry-- and the four drives on the amp are the furthest away vertically from the fuses.

There are two phoenix connectors on the back of the board. on the other side is cr br er .? Here are pics. And you can't make out the driver numbers very well but u have to trust me here. I have triple checked and they are the four at the bottom. P.S. I am liking the allen screws!. I still do...

Good Morning Lee I have all the output transistors installed. I have been trying to wire the board but I am having trouble with the diagram. You had mentioned that we have a upgraded rev (a) board. Is this why the diagram is not corresponding or is it me ? Would it be possible for you to draw...

Happy B-Day Perry! What is it 59 going on 32 ? LOL!:blob8:

Stranded it is. And thanks for all your time Lee!

Got it, I have some solid black wire, will that do?

Only because we did not find anything bad. My guess is the problem may be in the board. I am going to check just a bit. Is there anything on the board that comes to mind that may cause such a problem as dc current to the speaker outputs. ? Or if you were looking what components would you check...

Lee two more things, do we need to check the two square green caps on the back plain and I see a round ceramic cap as well. And will there be any soldering. I just got my wes51.

Yes I have the clips. I am very excited to wire up the board and install the outputs. But I have to say I am a bit worried about the back plane. other then that it is like, I friggin love it!

Lee, you said (posts) plural, that is why I got confused. I can think of a lot of things! LOL. But no, The rca connectors will come with the protection unit correct?

Like so--

Got it.